GET THE APP

..

Journal of Textile Science & Engineering

ISSN: 2165-8064

Open Access

Dorgham ME


Cairo
Egypt

Publications
  • Research Article
    Warping Parameters Influence on Warp Yarns Properties: Part 2: Warp Yarn Material and Cone position on Warping Creel
    Author(s): Dorgham MEDorgham ME

    Warping is a low yield operation owing to the time needed for creeling; the creels are the frames on which the cones which feed the warper are pinned. The number of cones depends on the type of fabric to be produced. The yarns are wound side by side and parallel one another on the beam, Also keep in mind that the number of yarns per beam is in the hundreds or thousands and that there must, at least, be one supply package for each of these yarns, if possible with the same tension, so the cone position and their accessibility are two important factors for the operator. This paper reports a study on producing 27 different material yarn samples by an indirect warping machine (Benninger, Ben-Ergotronic, Switzerland) used in part 1 with (V) shaped creel, the samples of the yarn manufactured from three different material (Cotton, Spun polyester and Polyacrylic) In addition, three diffe.. Read More»
    DOI: 10.4172/2165-8064.1000164

    Abstract PDF

Relevant Topics

Google Scholar citation report
Citations: 1008

Journal of Textile Science & Engineering received 1008 citations as per Google Scholar report

Journal of Textile Science & Engineering peer review process verified at publons

Indexed In

 
arrow_upward arrow_upward