Journal of Material Sciences & Engineering

Header Haddad

Publications

• Research Article
  Optimization of Moulding Technology of Polymer Concrete Used for Manufacture Precision Tool Machine Bases
  Author(s): Header Haddad and Igor SbarskiHeader Haddad and Igor Sbarski
  
  Aspects of moulding technology have a great effect on the mechanical properties and curing behaviour of polymer concrete used to manufacture the base of precision tool machine. In this paper, the results and the analysis are both presented of an experimental investigation on the effects of moulding technology on polymer concrete (PC) used for manufacture the base of precision tool machine. Effect of voids population on compressive strength of polymer concrete was examined. Various frequencies were applied during the packing operation of the polymer concrete samples using the vibration table. The optimum frequency for vibration and for producing a PC sample with the highest compressive strength was found to be 18.9375 Hz, which resulted in 109 MPa compressive strength for basalt, sand and chalk composition. In addition influence of Dimethyl aniline (DMA) amount and moulding temperature.. Read More»
  DOI: 10.4172/2169-0022.1000427

  Abstract PDF